Click for full size image.
Three head machine.
Completely striped down and rebuilt three years ago.
New bearings in the motors and oscillating heads.
New linear rail. Oversized precision rail, and re-bored sleeves
New Air clamps, support brackets, hoses, etc and cleaned, checked and painted.
This machine has had very little use and is no longer needed.
Located in Georgia USA.
The Maka motor plate electrics is shows that the machine was made for use in England, But has been set up to run on 230 volts supply In the USA by using a transformer. The motors will run 20% faster. Which is actually better for the smaller chisels sizes anyway.
Contact for information.